も仕分けありませんがこのページは日本語では入手不可

XRP Ledger Dev Portalをさまざまな言語で提供するよう努力していますが、すべてのページがすべての言語で利用できるわけではありません。助けたいと思うなら、提供して下さい!

Set Maximum Number of Peers

The rippled server has a configurable soft maximum number of peers to connect to. The default maximum number of peers is 21.

Note: Internally, the server generates approximate quotas of incoming and outgoing peers. You can potentially go over the soft maximum if you are using fixed peers, peer reservations, or if you manually connect to additional peers using the connect method.

To change the maximum number of peers your server allows, complete the following steps:

  1. Edit your rippled's config file.

    $ vim /etc/opt/ripple/rippled.cfg
    

    The recommended installation uses the config file /etc/opt/ripple/rippled.cfg by default. Other places you can put a config file include $HOME/.config/ripple/rippled.cfg (where $HOME is the home directory of the user running rippled), $HOME/.local/ripple/rippled.cfg, or the current working directory from where you start rippled.

  2. In the config file, uncomment and edit the [peers_max] stanza, or add one if you don't have one already:

    [peers_max]
    30
    

    The only content of the stanza should be an integer indicating the total number of peers to allow. By default, the server attempts to maintain a ratio of about 85% incoming and 15% outgoing peers, but with a minimum of 10 outgoing peers, so any value less than 68 won't increase the number of outgoing peer connections your server makes.

    If the [peers_max] value is less than 10, the server still allows a hardcoded minimum of 10 outgoing peers so that it can maintain connectivity with the network. To block all outgoing peer connections, configure the server as a private peer instead.

    Caution: The more peer servers you are connected to, the more network bandwidth your rippled server uses. You should only configure large numbers of peer servers if your rippled server has a good network connection and you can afford the costs you may incur for the bandwidth it uses.

  3. Restart the rippled server.

    $ sudo systemctl restart rippled.service
    

See Also