も仕分けありませんがこのページは日本語では入手不可

XRP Ledger Dev Portalをさまざまな言語で提供するよう努力していますが、すべてのページがすべての言語で利用できるわけではありません。助けたいと思うなら提供して下さい!

Manually Connect to a Specific Peer

Use these steps to manually connect your server to a specific peer in the XRP Ledger network.

Tip: If you want to make sure your server automatically connects to this server on startup and remains connected later, you may want to configure a peer reservation for that peer.

Prerequisites

  • You must know the IP address of the peer you want to connect to.
  • You must know what port the peer you want to connect to uses for the XRP Ledger peer protocol. By default, this is port 51235.
  • You must have a network connection from your server to the peer. For example, the peer server must forward the apppropriate port through its firewall.
  • The peer server must have available peer slots. If the peer is already at its maximum number of peers, you can ask the peer server's operator to add a peer reservation for your server.

Steps

To connect, use the connect method. For example:

{
    "command": "connect",
    "ip": "169.54.2.151",
    "port": 51235
}
{
    "method": "connect",
    "params": [
        {
            "ip": "169.54.2.151",
            "port": 51235
        }
    ]
}
rippled connect 169.54.2.151 51235

See Also